Wired Intelligent Edge

Hi,

The 1930 InstantOn is new in my setup. Everything else unchanged and worked for years with the same settings.
The 1930 replaced a stanadard hp L2 switch (1820).

Scan to network folder (to a DFS-drive) works with a freshly rebooted switch and fails after some time with an error telling the folder can't be reached.
Rebooting switch or printer will fix this - until it fails again after some time.

As the switch is the only new component, I'm looking for something failing here - but fail to find some proper logging showing any failure.

The switch setup is close to out of the box. It's configured as L2-switch. All components involved on the defaultVLAN, Ports configured accordingly.

It's only the scanning that fails.

Printing works and also the config-page of the printer can be reached when scanning fails.

Any ideas?

Thanks!

Please ask your question in  Aruba InstantON forum<u1:p></u1:p><u2:p></u2:p><u3:p></u3:p>

------------------------------
If my post was useful accept solution and/or give kudos.
Any opinions expressed here are solely my own and not necessarily that of HPE or Aruba.
------------------------------