Hello,
I have a site where we have 3 stacks of 5500G switches. Each stack is interconnected with the matrix cables, and the individual stacks are connected using fibre (a star from the coms room).
There are two VLANS in use one for the ground and first floor (VLAN2), the other for the second floor (VLAN3). The fibre connections are in VLAN2 on all switches. This configuration has been running for years no problem. We recently introduced radius authentication using free radius on a pair of SLES 10 servers. Testing on the ground floor was fine and this went into production rolling it out through the ground and first floor. When we introduced this to the second floor some workstations would become disconnected from the network (not always the same PC and not at the same time). That is to say the PC would power on and work normally but at some point the network connection would be closed. The quick fix is a reboot and the PC connects back to the network. I have compared the switch configurations and can see no difference (configs, firmware). The Radius Accounting log is showing what I believe to be normal operation, ‘Radius start’, ‘interim update’ but at the time of disconnection it is showing a ‘stop’ despite the PC being in use.
We have checked power save settings on the PC, we know the users are using the PC at time of disconnect.
Does anyone have any idea what may cause this or have any suggestions on how to diagnose this further?
Thanks in advance for any suggestions you can make.
JK