HPE Mist Networking

Can someone tell me the default username and password for the AX411 AP?

------------------------------
Adrian Aguinaga
B.S.C.M. I.T.T. Tech
(Construction Management)
A.A.S. I.T.T. Tech
(Drafting & Design)
------------------------------

That is a blast from the past and a very old box, that went EOL 10 years ago... If you have factory reset it, you might want to try:

• netscreen / netscreen
• root / (blank)

Then old possible randoms

admin / admin

admin / (blank)

root / juniper

------------------------------
Fred Glauser
------------------------------

Thx for your reply. This is much needed. Yes this unit is a bit outdated. But the technology has merit. Have a great day!!!!

------------------------------
Adrian Aguinaga
B.S.C.M. I.T.T. Tech
(Construction Management)
A.A.S. I.T.T. Tech
(Drafting & Design)
------------------------------

Original Message:
Sent: 09-02-2025 10:15
From: Fred Glauser
Subject: AX411 US

That is a blast from the past and a very old box, that went EOL 10 years ago... If you have factory reset it, you might want to try:

• netscreen / netscreen
• root / (blank)

Then old possible randoms

admin / admin

admin / (blank)

root / juniper

------------------------------
Fred Glauser
------------------------------

For the Aruba AX411 access point, the default login credentials are typically:

• Username:admin
• Password: the serial number of the AP

This applies to Instant Access Points (IAPs) running AOS-8.5.0.0 or later. If the AP is part of a cluster, you can use the serial number of any AP in the cluster as the password. For older versions (prior to AOS-8.5.0.0), the default password may still be admin.hpe

------------------------------
Matt Sherman
------------------------------

Thx, ill check!!!

------------------------------
Adrian Aguinaga
B.S.C.M. I.T.T. Tech
(Construction Management)
A.A.S. I.T.T. Tech
(Drafting & Design)
------------------------------

Original Message:
Sent: 09-02-2025 08:47
From: Matt Sherman
Subject: AX411 US

For the Aruba AX411 access point, the default login credentials are typically:

• Username:admin
• Password: the serial number of the AP

This applies to Instant Access Points (IAPs) running AOS-8.5.0.0 or later. If the AP is part of a cluster, you can use the serial number of any AP in the cluster as the password. For older versions (prior to AOS-8.5.0.0), the default password may still be admin.hpe

------------------------------
Matt Sherman
------------------------------