Wireless Access

 View Only
  • 1.  New Firewall Requirement for Controller initiated to Campus AP traffic after upgrade from 8.6 to 8.13?

    Posted Oct 15, 2026 04:31 PM

    Hello, we recently upgraded our environment from 8.6 to 8.13, and found a location that had AP's behind a set of firewalls where AP's would register, but users could not maintain a connection and get an IP.  During trial and error, we added a permit any rule for traffic initiated from the controller to the LAN the AP's were connected to and users were able to connect, get IP's.

    I have a question for the firewall team to see if they could provide any observations of new traffic, but wanted to see if anyone here knows what changed in the code revision for our upgrade (could be on any version between 8.6 and 8.13) where we need to permit specific traffic from the controllers (did find mention here on the forums to permit 8211, but that did not help).

    Thanks for all your insight.



  • 2.  RE: New Firewall Requirement for Controller initiated to Campus AP traffic after upgrade from 8.6 to 8.13?

    Posted Oct 15, 2026 08:07 PM

    here are the ports that are needed to be open for campus AP to communicate with the gateways/controller

    Understanding Firewall Port Configuration in Aruba Devices



    ------------------------------
    If my post was useful accept solution and/or give kudos.
    Any opinions expressed here are solely my own and not necessarily that of HPE or Aruba.
    ------------------------------



  • 3.  RE: New Firewall Requirement for Controller initiated to Campus AP traffic after upgrade from 8.6 to 8.13?

    Posted Oct 15, 2026 09:32 PM
    Thank you Ariya - 

    Appreciate the reference.

    More specifically, was looking for what was the change in requirements between 8.6 to 8.13 that needed a firewall rule modification as hosts were able to connect on 8.6, and unable to do so after the upgrade.  If we're too much into the weeds here, that's fine.  

    Thanks again everyone.






  • 4.  RE: New Firewall Requirement for Controller initiated to Campus AP traffic after upgrade from 8.6 to 8.13?

    Posted Oct 16, 2026 12:16 AM

    NP. 

    8.6 is really old, BTW here is the consolidated release notes for AOS8



    ------------------------------
    If my post was useful accept solution and/or give kudos.
    Any opinions expressed here are solely my own and not necessarily that of HPE or Aruba.
    ------------------------------



  • 5.  RE: New Firewall Requirement for Controller initiated to Campus AP traffic after upgrade from 8.6 to 8.13?

    Posted Oct 16, 2026 05:22 AM

    I'm not aware of changes of how APs communicate between version 8.6 and 8.13. It may be that in 8.6 you had control-plane security disabled and now enabled, but that was already the default and strongly recommended in 8.6. If you follow the firewall port configuration, you should be good. Also, make sure that Jumbo frames are supported between the AP and the controller.



    ------------------------------
    Herman Robers
    ------------------------
    If you have urgent issues, always contact your HPE Aruba Networking partner, distributor, or Aruba TAC Support. Check https://www.arubanetworks.com/support-services/contact-support/ for how to contact HPE Aruba Networking TAC. Any opinions expressed here are solely my own and not necessarily that of Hewlett Packard Enterprise or HPE Aruba Networking.

    In case your problem is solved, please invest the time to post a follow-up with the information on how you solved it. Others can benefit from that.
    ------------------------------